2003 Iveco Daily

Emissions unable to be completed exhaust blowing (8.2.2.2 (e))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition rear silencer missing (8.1.1 (a))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Outline marker lamp not working x3 (4.2.1 (a) (ii))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Outer Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Side repeater incorrect colour (4.4.3 (a))

Offside Front Outline marker lamp not working (4.2.1 (a) (ii))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Headlamp aim too far to the left (4.1.2 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Side repeater incorrect colour (4.4.3 (a))

Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Vehicle structure excessively corroded within 30cm of towbar mounting x3 (6.1.6 (i) (i))

Nearside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake disc worn, pitted or scored, but not seriously weakened all (1.1.14 (a) (ii))

slight corrosion to underside including suspension components

Brake hose has slight corrosion to ferrule all (1.1.12 (f) (i))

Brake hose slightly deteriorated all (1.1.12 (b) (ii))

Front Shock absorbers has a reduced damping effect both (5.3.2 (d))

corrosion to underside including suspension components

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner arch area (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner arch area (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Brake hose has slight corrosion to ferrule all (1.1.12 (f) (i))

Brake hose slightly deteriorated all (1.1.12 (b) (ii))

Front Shock absorbers has a reduced damping effect both (5.3.2 (d))

corrosion to underside including suspension components

Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Lower Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength out rigger all 3 (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outrigger all 3 (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases silencer broken at entry point (6.1.2 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear water tank straps corroded

uncerside corroded but not considered excessive

Offside Front Exhaust has a minor leak of exhaust gases pipe into silencer leaking (6.1.2 (a))

Nearside Front inner wing corroded in a non prescribed area

Offside Front Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive bulk head to inner wing (1.1.21 (e) (i))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security floor (6.2.2 (d) (i))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outriggers (6.2.2 (d) (i))

battery tray starting to corrode

exhaust tailpipe modified

rear axle sat on bump stops

battery tray starting to corrode

nearside front inner wing corroded in a non prescribed area

offside front bulk head to inner wing starting to corrode

rear floor starting to corrode in non prescribed areas

rear outriggers starting to corrode

rear suspension beam sat on bump stops

Exhaust has a major leak of exhaust gases (7.1.2)

Registration plate lamp not working (1.1.C.1d)

battery tray starting to corrode

nearside front inner wing corroded in a non prescribed area

offside front bulk head to inner wing starting to corrode

rear floor starting to corrode in non prescribed areas

rear outriggers starting to corrode

rear suspension beam sat on bump stops

Battery tray corroded, inner wings corroded

Chassis and floor corroded

Exhaust tailpipe missing

Front Brake hose has slight corrosion to ferrules All (3.6.B.4e)

Nearside Front Brake pipe slightly damaged lower inner wing (3.6.B.2c)

Rear beam sat on bump stops

Brake fluid warning lamp illuminated (3.6.G.2)

Brake pipe excessively corroded Front to rear sections above fuel tank (3.6.B.2c)

Horn not working (1.6.2a)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside rear brake excessively fluctuating (3.7.B.3)

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded inner wing (3.6.C.3)

Offside Front Brake pipe inadequately clipped bulkhead (3.6.B.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Parking brake lever has no reserve travel (3.1.6b)

Rear Brake pipe excessively corroded across beam (3.6.B.2c)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Battery tray corroded, inner wings corroded

Chassis and floor corroded

Exhaust tailpipe missing

Front Brake hose has slight corrosion to ferrules All (3.6.B.4e)

Nearside Front Brake pipe slightly damaged lower inner wing (3.6.B.2c)

Rear beam sat on bump stops

Supplementary Restraint System warning lamp does not illuminate (5.4.2)

front body mounts perishing

near side side markers not working

rear exhaust corroded

slight blow at front flexi

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Rear fog lamp not working (1.3.2b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

front body mounts perishing

near side side markers not working

rear exhaust corroded

slight blow at front flexi

Offside Windscreen wiper not operating automatically when switched on (8.2.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

slight play in ball joints

Bonnet cannot be secured in the closed position (8.4.1)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Rear Leaf spring fractured (2.4.B.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Leaf spring fractured (2.4.B.1a)

Offside Rear fog lamp not working (1.3.2b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear fog lamp tell tale not working (1.3.1b)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Brake load sensing valve linkage seized (3.6.E.3)

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Brakes imbalanced across an axle (3.7.B.5b)

Centre Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside All position lamps not working (1.1.A.3b)

Nearside Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim too low (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Side repeater incorrect colour (1.4.A.2f)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Bonnet cannot be secured in the closed position (8.4.1)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp insecure (1.7.3)

Offside Stop lamp emits other than a steady red light (1.2.1e)

Front Brake pad(s) wearing thin (3.5.1g)

rear brake effort meets minimum requirements but performance is questioable

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)