2008 Mercedes-benz Vito

Brake pedal wearing smooth (1.1.2 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Central Rear Seat belt not functioning as intended (7.1.2 (c))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pedal wearing smooth (1.1.2 (c))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too low (4.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too low (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill corners both sides (5.3.6 (a) (i))

Stop lamp(s) not working (4.3.1 (a) (ii))

Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Vehicles internal headlight adjuster altered to recheck lights

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Seat belt buckle not functioning as intended row 2 centre belt buckle (7.1.2 (d))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

exhaust clamps corroded

nearside parking brake efficiency

Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Road wheel slightly distorted (5.2.2 (c) (i))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Bonnet primary retaining device excessively deteriorated (3.1 (c))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Road wheel slightly distorted (5.2.2 (c) (i))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material flexi inwards (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material flexi inwards (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material flexi inwards (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material flexi inwards (1.1.11 (c))

Brake pipe corroded, covered in grease or other material brake pipes (1.1.11 (c))

bonnet difficult to open

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust has a minor leak of exhaust gases FLEXY (6.1.2 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material AND O/S/R (1.1.11 (c))

Parking brake lever has little reserve travel (3.1.6b)

Rear Brake pipe slightly corroded and o/s/r (3.6.B.2c)

Parking brake lever has little reserve travel (3.1.6b)

oil leak

Oil leak

emissions not tested

nearside front tyre worn on outer edge

offside front tyre worn on outer edge

Parking brake lever has no reserve travel (3.1.6b)

Windscreen washer provides insufficient washer liquid (8.2.3)

nearside front tyre worn on outer edge

offside front tyre worn on outer edge

Rear Brake pad(s) wearing thin (3.5.1g)

rear discs worn