2010 BMW 116

Inner Integral body structure is corroded but structural rigidity is not significantly reduced sills both sides (6.1.1 (c) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

underside covered in thick dirty grease

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

front number plate cracked

underbody of car covered in grease like substance

Nearside Front Anti-roll bar linkage likely to fail (5.3.3 (b) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

front number plate cracked

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

underbody of car covered in grease like substance

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

underbody of car covered in grease like substance

under tray fitted

Anti-roll bar ball joint has slight play Both front link bars (5.3.4 (a) (i))

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Shock absorbers light misting of oil or has limited damping effect front and rear (5.3.2 (b))

Rear Tyre worn close to legal limit/worn on edge Both (5.2.3 (e))

Front Headlamp aim too low o/s and n/s (1.8)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Rear Upper Suspension arm has slight play in a pin/bush o/s and n/s (2.4.G.2)

Rear Tyre tread depth below requirements of 1.6mm o/s and n/s (4.1.E.1)

Rear Upper Suspension arm has slight play in a pin/bush o/s and n/s (2.4.G.2)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)