2010 Peugeot 107

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced full sill at seam to inner sill (6.1.1 (c) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Inner Brake pad(s) wearing thin nsf / osf (1.1.13 (a) (ii))

NSF / OSR reg light lens missing

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Front Inner Brake pad(s) wearing thin nsf / osf (1.1.13 (a) (ii))

NSF / OSR reg light lens missing

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Nail in tyre ()

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill (6.1.1 (c) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill (6.1.1 (c) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Nail in tyre ()

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Outer sill (6.1.1 (c) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Outer sill (6.2.2 (d) (i))

Offside Front Suspension arm pin or bush excessively worn Rear bush (5.3.4 (a) (i))

Offside Rear Brake pipe excessively damaged Front to rear, bent at flexi pipe (1.1.11 (c))

Exhaust mounting defective Middle pipe (6.1.2 (a))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Outer sill (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust mounting defective middle pipe (6.1.2 (a))

clutch knothcy

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength Strut mounting point for coil spring (5.3.6 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords badly perished and cracked (5.2.3 (d) (i))

Emissions not tested exhaust blowing (7.3.A.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)