2006 Volkswagen Beetle

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill (5.3.6 (a) (ii)) DANGEROUS

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Exhaust has a minor leak of exhaust gases corroded. (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge Edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Nearside Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Nearside Front Upper Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Central Exhaust system not adequately supported (7.1.1)

Nearside Front Upper Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front passenger door cannot be opened from outside the vehicle (6.2.B.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Outer Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Outer Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear coil spring incomplete (2.4.C.1a)