2007 Jaguar X-type

Crank pulley noisey

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Innersill (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Inner sill (5.3.6 (a) (ii)) DANGEROUS

Crank pulley noisey

Nearside Headlamp aim too high (4.1.2 (a))

Windscreen washer not working (3.5 (a))

under trays fitted

Suspension component mounting prescribed area is corroded but not considered excessive front rear (5.3.6 (a) (i))

service brake efficiency only just met/it would appear that the braking system requires adjustment or repair.

Front Play in steering rack inner joint(s) ()

Rear Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Tyre worn close to legal limit/worn on edge both front,osr. (5.2.3 (e))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill corroded (7.1.1 (a) (i))

Front Play in steering rack inner joint(s) ()

Rear Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Tyre worn close to legal limit/worn on edge both front,osr. (5.2.3 (e))

Nearside Headlamp aim too low (1.8)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

o/side front tyre slight damage to wall