2003 Fiat Ducato

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Suspension arm has excessive play in a pin/bush both bushes (2.4.G.2)

Nearside Front Wheel bolt(s) missing (4.2.A.1e)

Nearside Rear Inner Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Brake pipe excessively damaged flexi (3.6.B.2c)

Offside Front Inner Front constant velocity joint is insecure (2.5.C.1b)

Offside Front Side repeater insecure (1.4.A.2b)

Offside Front Suspension arm has excessive play in a pin/bush both bushes (2.4.G.2)

Steering wheel locking device insecure (2.1.6)

Tailgate cannot be secured in the closed position (6.4.1)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Seat belt cut but webbing not significantly weakened (5.2.2a)

Nearside Front wing mirror damage

Nearside Rear light cluster damaged

Nearside sill corrosion

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear light cluster damaged

Offside sill corrosion

oil leak

brake pedal spongy-x2 inner and outer sills corroded

front and rear brakes juddering-drivers seat torn-handbrake lever slightly sticking

oil leak,due to oil leak unable to check components properly

pb cables corroded-exhaust and mountings corroded-all inner arches corroded

x2 rear wheel bearings slight play-x2 rear leaf springs corroded

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc inner cv boot split (2.5.C.1a)

Nearside Front front brake binding (3.7.B.1)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working x2 (1.1.C.1d)

Suspension component mounting prescribed area is excessively corroded n/s inner middle sill holed multiple places (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded n/s outer sill holed multiple places (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded n/s/r outer sill holed (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded o/s inner middle sill holed (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded o/s inner sill holed multiple places (2.4.A.3)

Suspension component mounting prescribed area is excessively corroded o/s outer sill holed (2.4.A.3)

Tyre tread depth below requirements of 1.6mm x2 front (4.1.E.1)

rear brake excessively fluctuating rear brakes juddering (3.7.B.3)

brake pedal spongy-x2 inner and outer sills corroded

front and rear brakes juddering-drivers seat torn-handbrake lever slightly sticking

oil leak,due to oil leak unable to check components properly

pb cables corroded-exhaust and mountings corroded-all inner arches corroded

x2 rear wheel bearings slight play-x2 rear leaf springs corroded

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

front shockers damp-front tyres low-sills corroded inner arches corroded-rear tyres low

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Registration plate lamp not working (1.1.C.1d)

front brake application uneven (3.7.B.2)

front brakes release unevenly (3.7.B.4)

Brake load sensing valve seized (3.6.E.3)

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Brake pedal creeps down while the pedal is held under pressure (3.3.B.1a)

Centre Stop lamp not working (1.2.1b)

Front registration plate delaminated (6.3.1d)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen wiper blade insecure (8.2.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside front brake binding (3.7.B.1)

Registration plate lamp not working (1.1.C.1d)

Windscreen has a combination of minor damage areas which restrict the drivers view (8.3.1c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brake load sensing valve linkage stiff (3.6.E.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Exhaust has part of the system slightly deteriorated (7.1.1a)

Oil leak

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Brake load sensing valve linkage stiff (3.6.E.3)

Oil leak

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Stop lamp not working (1.2.1b)