2006 BMW 630

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pipe corroded, covered in grease or other material Both, By Front Flexis (1.1.11 (c))

Nearside Rear Outer Suspension arm ball joint has slight play Marked (5.3.4 (a) (i))

Offside Rear Brake pipe inadequately clipped or supported Over Rear Diff (1.1.11 (d) (i))

Nearside Rear Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pipe corroded, covered in grease or other material Both, By Front Flexis (1.1.11 (c))

Nearside Rear Outer Suspension arm ball joint has slight play Marked (5.3.4 (a) (i))

Offside Rear Brake pipe inadequately clipped or supported Over Rear Diff (1.1.11 (d) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Front brake discs inner surface lipped

Front brake pads inner low

Front brake pipes surface rusty

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Front Brake pad(s) wearing thin inner side 3mm (1.1.13 (a) (ii))

Front Brake pipe corroded, covered in grease or other material both side to flexi pipe (1.1.11 (c))

Front Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Nearside Rear Nail in tyre ()

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement rear susp. arm front bush ( Both ) (5.3.4 (a) (i))

Rear Wheel bearing slightly noisy both (5.1.3 (b) (i))

Rear Brake pipe excessively corroded both side to flexi pipe, and above rear sub frame (1.1.11 (c))

Front Brake pad(s) wearing thin inner side 3mm (1.1.13 (a) (ii))

Front Brake pipe corroded, covered in grease or other material both side to flexi pipe (1.1.11 (c))

Front Shock absorbers light misting of oil or has limited damping effect both (5.3.2 (b))

Nearside Rear Nail in tyre ()

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement rear susp. arm front bush ( Both ) (5.3.4 (a) (i))

Rear Wheel bearing slightly noisy both (5.1.3 (b) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Engine management light is on

Nearside Front Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Engine management light is on

Nearside Front Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Rear Tyre worn close to the legal limit Inner edge (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)