2003 BMW X5

Brake pipe corroded, covered in grease or other material above rear axle. (1.1.11 (c))

Central Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge Inner edge (5.2.3 (e))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge Inner edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear tyre has damage to outer wall

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear tyre has damage to outer wall

Nearside Front Lower Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

o/s outer door handle stiff to operate

Nearside Front Tyre worn close to the legal limit worn inner edge (4.1.E.1)

Nearside Lower Front suspension ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit worn inner edge (4.1.E.1)

Offside Rear Tyre worn close to the legal limit worn inner edge (4.1.E.1)

o/s windscreen chipped

Engine covers fitted obscuring some components in the engine bay

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

Under-trays fitted obscuring some underside components

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

offside rear tyre worn to inner edge

Engine covers fitted obscuring some components in the engine bay

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

Oil leak

Under-trays fitted obscuring some underside components

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

offside rear tyre worn to inner edge

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Engine covers fitted obscuring some components in the engine bay

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Oil leak

Under-trays fitted obscuring some underside components

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

offside rear tyre worn to inner edge

Driver's door cannot be opened from outside the vehicle (6.2.B.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Headlamp aim too low (1.8)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Headlamp aim too low (1.8)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Sub-frame has slight play in a pin/bush (2.4.G.2)

Offside Rear Sub-frame has slight play in a pin/bush (2.4.G.2)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front Drag link end ball joint has slight play (2.2.B.1f)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Front Tyre worn close to the legal limit (4.1.E.1)

Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)