MOT Status
ExpiredMileage
140,831 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Front Brake pad(s) wearing thin (1.1.13 (a) (ii))
Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))
Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))
Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))
Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))
Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))
Front Brake pad(s) wearing thin (1.1.13 (a) (ii))
Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))
Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))
Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS
Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rearmost bush (5.3.4 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rearmost bush (5.3.4 (a) (i))
Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS
Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rearmost bush (5.3.4 (a) (i))
Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rearmost bush (5.3.4 (a) (i))
Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))
Rear Exhaust mounting defective (6.1.2 (a))
Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement and offside front rear most bush (2.4.G.2)
Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement and offside front rear most bush (2.4.G.2)
Nearside Front position lamp(s) not working (1.1.A.3b)
rear exhaust tail pipe mount detached but system well supported
Nearside Registration plate lamp not working (1.1.C.1d)
rear exhaust tail pipe mount detached but system well supported
exhaust tail pipe hanger bracket detached but system adequately supported
Rear Brake pad(s) wearing thin (3.5.1g)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
Rear Brake pad(s) wearing thin (3.5.1g)
Nearside Front Brake pad(s) wearing thin (3.5.1g)
Offside Front Brake pad(s) wearing thin (3.5.1g)
Front Brake pad(s) wearing thin (3.5.1g)
Service brake only just meets the required efficiency @ 56%. Parking brake only just meets the required efficiency @ 17%. The braking system may require adjustment or repair.
Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Front Brake pad(s) wearing thin (3.5.1g)
Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
o/s/r seatbelt unable to fully inspect child seat fitted
Tyre worn close to the legal limit (4.1.E.1)
How Reliable is the Mazda 3?
Based on 2,040,939 MOT tests across 164,053 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
YL55 MFP is a 2006 Mazda 3 in Grey with a 1,598cc petrol engine. This vehicle has been through 22 MOT tests with a personal pass rate of 68.2%.
Across all 2006 Mazda 3 models, the average MOT pass rate is 74.6% with a typical mileage of 70,278 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Mazda 3 fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 40,716 recorded failures. If you're considering buying YL55 MFP, it's worth having these areas checked by a mechanic before committing.
The Mazda 3 typically stays on UK roads for around 22 years. At 20 years old, this Mazda 3 is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of YL55 MFP?
You can check the full history of YL55 MFP by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was YL55 MFP registered?
YL55 MFP is a 2006 Mazda 3, first registered on 31 January 2006.
Is YL55 MFP safe to buy?
The MOT history for YL55 MFP shows 22 tests with a 68.2% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does YL55 MFP have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on YL55 MFP. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.