2008 Piaggio Fly

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Nearside Brake lever has insufficient reserve travel (1.1.2 (a))

Rear Lower Suspension component pin or bush excessively worn linkage (5.3.4 (a) (i))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Rear Lower Suspension component attachment bracket/mounting likely to fail linkage (5.3.3 (b) (ii)) DANGEROUS

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Exhaust slightly loose (6.1.2 (a))

Front Brake disc worn, but not excessively borderline (1.1.14 (a) (i))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Front brake pads corroded ?

Lower Motorcycle structure is corroded but structural rigidity is not significantly reduced borderline (6.1.1 (c) (i))

Nearside Front Upper Suspension corroded but not seriously weakened fork (5.3.3 (b) (i))

Nearside Indicator tell tale inoperative (4.9.1 (a) (i))

Offside Front Upper Suspension corroded but not seriously weakened fork (5.3.3 (b) (i))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Rear shock absorber seal failed and leaking oil (2.4.A.1c)

part of front engine case missing

Nearside Rear suspension bush has excessive free play (2.4.A2a(i))

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front suspension has a slightly reduced damping effect (2.3.6c)

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Front suspension has a slightly reduced damping effect (2.3.6c)

Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))