2008 Lexus RX400H

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced (5.3.3 (b) (i))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Front Service brake excessively fluctuating (1.2.1 (e))

Front Windscreen washer not working (3.5 (a))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre has ply or cords exposed inner edge (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed inner edge (5.2.3 (d) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced (5.3.3 (b) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Sub-frame corroded but not seriously weakened both (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement NEARSIDE AND OFFSIDE - BACK BUSHES (5.3.4 (a) (i))

Nearside Front Nail in tyre

Offside Rear Nail in tyre

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security NEARSIDE AND OFFSIDE (6.2.2 (d) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement FRONT AND BACK BUSHES (5.3.4 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement NEARSIDE AND OFFSIDE - BACK BUSHES (5.3.4 (a) (i))

Nearside Front Nail in tyre

Offside Rear Nail in tyre

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security NEARSIDE AND OFFSIDE (6.2.2 (d) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement FRONT AND BACK BUSHES (5.3.4 (a) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust heat shield loose

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Lower arm bushes (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Lower arm bushes (5.3.4 (a) (i))

Rear Fuel Pipe/s corroded

Rear axle swivel bushes slightly deteriorated

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Rear Fuel Pipe/s corroded filler neck

rear heat shield loose but not likely to fall off by fuel tank

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords x2 (5.2.3 (d) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear wheel slightly binding

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Fuel Pipe/s corroded filler neck

rear heat shield loose but not likely to fall off by fuel tank

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

fuel tank filler neck pipe slightly corroded

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Headlamp aim too high (1.8)

engine & under trays

Brakes imbalanced across an axle (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)