2004 Fiat Ducato

general underside corrosion

Service brake efficiency below requirements (1.2.2 (a) (i))

general underside corrosion

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive front mount-upper and low chassis leg (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive rear mount (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive rear mount (5.3.6 (a) (i))

Rear Brake prescribed area is corroded but not considered excessive cross member-load sensing valve (1.1.21 (e) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive cross member (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength rear mounting point (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive front mount-upper and low chassis leg (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive rear mount (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive rear mount (5.3.6 (a) (i))

Rear Brake prescribed area is corroded but not considered excessive cross member-load sensing valve (1.1.21 (e) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive cross member (5.3.6 (a) (i))

Nearside Front Brake hose ferrule excessively corroded x2 (1.1.12 (f) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis leg (6.1.1 (c) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Windscreen washer provides insufficient washer liquid both front (3.5 (a))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Both rear tyres perished and cracking

Horn not working (7.7 (a) (ii))

Both rear tyres perished and cracking

Front coil spring corroded (2.4.C.1b)

all four tyres cracking on side wall

under body corrosion on rear chassis rails

Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings both front step sills (6.1.B.2)

Body has slight corrosion both front inner wheel arches (6.1.B.2)

Rear Body has slight corrosion (6.1.B.2)

brake disc worn, pitted or scored, but not seriously weakened both front (3.5.1i)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

tyres perishing

Nearside rear brake grabbing slightly (3.7.A.5b)

Offside rear brake grabbing slightly (3.7.A.5b)

Offside Registration plate lamp not working (1.1.C.1d)