2008 Toyota Aygo

Exhaust has a minor leak of exhaust gases rear clamp (6.1.2 (a))

Macpherson strut pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Suspension component mounting prescribed area excessively damaged significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively damaged significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively damaged significantly reducing structural strength outer sill (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases rear clamp (6.1.2 (a))

Macpherson strut pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

General condition of under body chassis on rear is corroded

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear exhaust tail box corroded

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill corroded (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner & outer sill corroded (5.3.6 (a) (i))

General condition of under body chassis on rear is corroded

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear exhaust tail box corroded

Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Front Position lamp not working (4.2.1 (a) (ii))

Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced complete sil (6.1.1 (c) (i))

Nearside Rear Coil spring corroded so that its cross sectional area is reduced and seriously weakened (5.3.1 (b) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Coil spring corroded so that its cross sectional area is reduced and seriously weakened (5.3.1 (b) (i))

Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Inner Suspension arm pin or bush excessively worn rear. (5.3.4 (a) (i))

Nearside Headlamp aim too low bulb mounted incorrectly. (4.1.2 (a))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Inner Suspension arm pin or bush excessively worn rear. (5.3.4 (a) (i))

Offside Rear Lower Subframe mounting prescribed area excessively corroded significantly reducing structural strength outer door sill. (5.3.6 (a) (i))

Offside Rear Road wheel badly distorted (5.2.2 (c) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake pipe slightly corroded (3.6.B.2c)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both wishbone arms (2.4.G.2)

both sill panels damaged

nearside tyre wall damaged/cut

presenter adviced

Nearside front brake juddering slightly (3.7.A.2b)