2005 Toyota Land Cruiser

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced near bump stop (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated pin hole (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement "d" bush. (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Body mounting has some corrosion.

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Headlamp light source and lamp not compatible (4.1.4 (c))

Offside Headlamp light source and lamp not compatible (4.1.4 (c))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement "d" bush. (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Body mounting has some corrosion.

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Front Headlamp light source and lamp not compatible Led dip and main beam bulbs fitted to n/s and o/s. (4.1.4 (c))

Nearside Front Service brake excessively binding (1.2.1 (f))

Registration plate lamp inoperative in the case of a single lamp or all lamps Both lamps. (4.7.1 (b) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Front Suspension spring mounting prescribed area is corroded but not considered excessive both lower spring mounts are corroded slightly (5.3.6 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Front Suspension spring mounting prescribed area is corroded but not considered excessive both lower spring mounts are corroded slightly (5.3.6 (a) (i))

Rear Service brake binding but not excessively both (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe excessively corroded o/s/f + n/s/f (3.6.B.2c)

Front rear brake excessively fluctuating (3.7.B.3)

Rear rear brake excessively fluctuating (3.7.B.3)

Vehicle structure excessively corroded within 30cm of towbar mounting rear cross member (6.6.6)

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords ALL (4.1.D.1a)

both rear tyres worn on inner edges