2008 Toyota Aygo

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill to floor (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing outer edge (5.2.3 (d) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength seal (5.3.6 (a) (i))

Front Anti-roll bar damaged but not seriously weakened both sides (5.3.3 (b) (i))

Front Coil spring corroded both sides (5.3.1 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Service brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Coil spring corroded so that its cross sectional area is reduced and seriously weakened X2 (5.3.1 (b) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Axle has slight vertical movement between stub axle and axle beam axle corroded (5.1.2 (c) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill holed (6.2.2 (d) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

corosion through out vehicle

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cill (5.3.6 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cill (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

corosion through out vehicle

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Brake pipe slightly corroded front to rear section joining rear hose (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear rear brake binding (3.7.B.1)

Nearside Brake pipe slightly corroded front to rear section joining rear hose (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded front to rear at hose (3.6.B.2c)