2008 Toyota Aygo

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is repaired but structural rigidity is not significantly reduced BOTH SIDES INNER SILL (6.1.1 (d) (i))

Integral body structure is repaired but structural rigidity is not significantly reduced BOTH SIDES OUTER SILL (6.1.1 (d) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is repaired but structural rigidity is not significantly reduced BOTH SIDES INNER SILL (6.1.1 (d) (i))

Integral body structure is repaired but structural rigidity is not significantly reduced BOTH SIDES OUTER SILL (6.1.1 (d) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

n/s/r and o/s/r sill have filler on them can not inspect the sill properly

under car age realtered rust

Offside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

n/s/r and o/s/r sill have filler on them can not inspect the sill properly

under car age realtered rust

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Position lamp not working (4.2.1 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced side sill (6.1.1 (c) (i))

Offside Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both nearside & offside (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened Both nearside & offside (5.3.3 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded both nearside & offside (5.3.1 (b) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

o/s/f tyre worn on inside edge

Offside rear brake binding (3.7.B.1)

Nearside Rear Brake pipe slightly corroded front to rear (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded front to rear (3.6.B.2c)

n/s/r brake binding slightly

o/s/f tyre worn on inside edge

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded front to rear (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded front to rear (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm 155/65/14 (4.1.E.1)

Offside Front Tyre worn close to the legal limit 155/65/14 (4.1.E.1)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)