2012 Alfa Romeo Mito

Coil spring corroded front/rear o/s and n/s (5.3.1 (b) (i))

Front Tyre worn close to legal limit/worn on edge o/s and n/s (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Both front tyres worn low on inner edges

Oil leak

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside park brake effort low

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Engine mounting bracket damaged or deteriorated resulting in excessive movement (6.1.8 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

All brake discs rusty as if standing

Exhaust rear box corroded

All brake discs rusty as if standing

Exhaust rear box corroded

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front strut top bearing defective

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front strut top bearing defective

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))