2005 Subaru Outback

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

corrosion to vehicle

corrosion to vehicle

front cross member has corrosion

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor/ jacking point (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge on limit (5.2.3 (e))

corrosion to vehicle

front cross member has corrosion

Corrosion to brake pipes

Corrosion to vehicle

Exhaust has a minor leak of exhaust gases Front exhaust flange (6.1.2 (a))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security innersills underbody and chassis components corroded (6.2.2 (d) (i))

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Deep cut on offside front tyre tread

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Deep cut on offside front tyre tread

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)