2011 Ford Mondeo

Coil spring corroded both rear (5.3.1 (b) (i))

Front Brake pad(s) wearing thin both (1.1.13 (a) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front inner wheel arch missing

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Anti-roll bar ball joint has slight play both (5.3.4 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement rear trailing arm bushes (5.3.4 (a) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Coil spring corroded both rear (5.3.1 (b) (i))

Front Brake pad(s) wearing thin both (1.1.13 (a) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front inner wheel arch missing

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Anti-roll bar ball joint has slight play both (5.3.4 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement rear trailing arm bushes (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Wheel nut(s) missing 4 missing (4.2.A.1e)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Offside Front Seat belt stitching slightly frayed (5.2.2b)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)