2005 Fiat Idea

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested due to exhaust leaking gases from front flexi and rear back box / joint (7.3.A.1)

Front Exhaust has a major leak of exhaust gases front flexi pipe leaking (7.1.2)

Nearside Front Brake performance not tested brake binding (3.7.A.1)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Brake performance not tested (3.7.A.1)

Offside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases rear back box corroded and leaking (7.1.2)

Front Oil leak oil leak from side and front of engine ()

Nearside Front drive shaft seal leaking

Nearside Front wiper split

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

Rear wiper split

Nearside Front Shock absorber has a light misting of oil (2.7.3)

back box outer skin corroded

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Shock absorber has an excessively worn bush (2.7.4)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Shock absorber has an excessively worn bush (2.7.4)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

n/s headlamp is taped across the upper edge with duck tape, this was sufficient enough at time of test

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Hazard warning switch faulty (1.4.B.1d)