2006 Toyota Aygo

Brake pipe corroded, covered in grease or other material ALL (1.1.11 (c))

Front Drive shaft joint constant velocity boot severely deteriorated BOTH SIDES (6.1.7 (g) (i))

Rear Coil spring corroded BOTH SIDES (5.3.1 (b) (i))

Rear Shock absorbers has a slightly worn bush BOTH SIDES (5.3.2 (c))

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

UNDERBODY CORROSION (FRAMES AND SUSPENSION COMPONENTS)

sills corroded, brake discs worn, cv boots grease but no holes visible, springs corroded, shocker casings corroded, exhaust system corroded, play in rack

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Windscreen washer provides insufficient washer liquid (3.5 (a))

sills corroded, brake discs worn, cv boots grease but no holes visible, springs corroded, shocker casings corroded, exhaust system corroded, play in rack

Front Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner sills (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner sills (6.1.1 (c) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps both (4.7.2 (a))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Front Brake pipe slightly corroded to rear (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)

Rear Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pipe slightly corroded to rear (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Headlamp aim too high and too far to the right. (1.8)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Headlamp aim too low (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)