2006 Kia Sorento

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outer sill (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outer sill (6.2.2 (d) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outer sill (6.2.2 (d) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outer sill (6.2.2 (d) (i))

Brake pipe corroded, covered in grease or other material Both front to rears (At rear) (1.1.11 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced Sills)(Both sides (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Axle (5.3.6 (a) (i))

Offside Front Inner Tyre has a bulge, caused by separation or partial failure of its structure Sid wall (5.2.3 (d) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material Both front to rears (At rear) (1.1.11 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced Sills)(Both sides (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Brake pipe excessively corroded both rear (1.1.11 (c))

Nearside rear brake binding (3.7.B.1)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)