MOT Status
ExpiredMileage
158,341 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Nearside Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Undersill (5.3.6 (a) (i))
Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))
Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Offside Rear Suspension component mounting prescribed area damaged but not considered excessive Undersill (5.3.6 (a) (i))
Rear Sub-frame corroded but not seriously weakened Also tie arm mounts (5.3.3 (b) (i))
Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))
Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))
Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))
Nearside Front Steering locking device missing Track rod end split pin missing (2.1.3 (d))
Both sills heavily corroded
Brake pipe inadequately clipped or supported Both rear brake pipes. Supporting clip not secure (1.1.11 (d) (i))
Offside Rear Brake pipe corroded, covered in grease or other material Brake pipe corroded (1.1.11 (c))
Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Underbody corroded
Battery insecure and likely to cause a short circuit (4.13 (a) (ii))
Emissions not tested no cat (8.2.1.2 (d))
Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))
Exhaust system insecure (6.1.2 (a))
Nearside Front Tyre fouling a part of the vehicle (5.2.3 (f))
Offside Front Service brake excessively binding unable to check condition or security of wheel bearing (1.2.1 (f))
Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))
Integral body structure is corroded but structural rigidity is not significantly reduced both inner sills (6.1.1 (c) (i))
Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear arm (5.3.4 (a) (i))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear arm (5.3.4 (a) (i))
Suspension component mounting prescribed area is corroded but not considered excessive both rear inner 1/4 panels and inner sills (5.3.6 (a) (i))
Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill bottom (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill bottom (5.3.6 (a) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear arm (5.3.4 (a) (i))
Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear arm (5.3.4 (a) (i))
Registration plate lamp throwing direct white light to the rear (4.7.1 (a))
Suspension component mounting prescribed area is corroded but not considered excessive both rear inner 1/4 panels and inner sills (5.3.6 (a) (i))
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))
Offside Rear fog lamp not working (4.5.1 (a) (ii))
Nearside Rear Lower Suspension arm pin or bush excessively worn outer bush (5.3.4 (a) (i))
Offside Rear Lower Suspension arm pin or bush excessively worn outer bush (5.3.4 (a) (i))
Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))
Nearside Front Front position lamp(s) not working (1.1.A.3b)
Nearside Rear Registration plate lamp not working (1.1.C.1d)
Offside Front Front position lamp(s) not working (1.1.A.3b)
Offside Rear Registration plate lamp not working (1.1.C.1d)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Offside Front Shock absorber has a light misting of oil (2.7.3)
Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
Nearside Tyre worn close to the legal limit (4.1.E.1)
Rear Brake pad(s) wearing thin (3.5.1g)
Rear Tyre worn close to the legal limit (4.1.E.1)
Offside Rear Shock absorber has a light misting of oil (2.7.3)
Rear Brake pad(s) wearing thin (3.5.1g)
Front Windscreen wiper does not clear the windscreen effectively (8.2.2)
Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Stop lamp not working (1.2.1b)
Rear registration plate insecure (6.3.1b)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
Brakes imbalanced across an axle (3.7.B.5b)
Nearside Front position lamp(s) not working (1.1.A.3b)
Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)
Offside Front position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Front Brake pad(s) less than 1.5 mm thick (3.5.1g)
Offside Front position lamp(s) not working (1.1.A.3b)
Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)
Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
front brake pads worn low
offside front tyre worn low
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Front Brake pad(s) wearing thin (3.5.1g)
Front Brake pad(s) wearing thin (3.5.1g)
Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)
How Reliable is the Lexus IS200?
Based on 546,826 MOT tests across 35,416 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
YS03 FYB is a 2003 Lexus IS200 in Silver with a 1,988cc petrol engine. This vehicle has been through 27 MOT tests with a personal pass rate of 59.3%.
Across all 2003 Lexus IS200 models, the average MOT pass rate is 77.2% with a typical mileage of 75,576 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Lexus IS200 fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 31,437 recorded failures. If you're considering buying YS03 FYB, it's worth having these areas checked by a mechanic before committing.
The Lexus IS200 typically stays on UK roads for around 27 years. At 23 years old, this Lexus IS200 is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of YS03 FYB?
You can check the full history of YS03 FYB by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was YS03 FYB registered?
YS03 FYB is a 2003 Lexus IS200, first registered on 1 June 2003.
Is YS03 FYB safe to buy?
The MOT history for YS03 FYB shows 27 tests with a 59.3% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does YS03 FYB have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on YS03 FYB. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.