2005 Mitsubishi Lancer

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing by strut top mount (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Front Exhaust has a minor leak of exhaust gases has been temp repaired (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive box sill (5.3.6 (a) (i))

Nearside Rear Nail in tyre

Nearside Side repeater lens defective which has no effect on emitted light also body work damaged (4.4.1 (b) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive box sill (5.3.6 (a) (i))

Oil leak, but not excessive from filter (8.4.1 (a) (i))

Outer door sills covered. both

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Underside corroded

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Rear arch corroded

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement n/s and o/s (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material n/s and o/s (1.1.11 (c))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive various section front and rear (7.1.1 (a) (i))

Suspension component corroded but not seriously weakened various front and rear (5.3.3 (b) (i))

exhaust system corroded

Brake disc worn, pitted or scored, but not seriously weakened both rear discs pitted (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material both rear section of pipe corroded slightly (1.1.11 (c))

exhaust back box hanger needs welding back on

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)