2007 Peugeot 107

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Shock absorbers has slight external damage to the casing both side (5.3.2 (b))

under the car slight corroosion front too rear plus seal inner

Front Lower Suspension arm pin or bush excessively worn both side (5.3.4 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

under the car slight corroosion front too rear plus seal inner

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

SLIGHT UNDER BODY CORROSION

SUB FRAME CORRODED

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

slight corrosion on rear coil springs

Nearside Headlamp aim too low (4.1.2 (a))

slight corrosion on rear coil springs

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp levelling device inoperative (4.1.5 (a))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength arch (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Rear Tyre worn close to legal limit/worn on edge both @2.2mm (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust noisy (8.1.1 (a))

Offside Brake pipe excessively corroded rear tip of o\s front to rear (1.1.11 (c))

Exhaust mounting defective back box rubber missing (6.1.2 (a))

Exhaust mounting defective hanger after the flexible section not in the rubber and is bent due to corrosion (6.1.2 (a))

Front Tyre worn close to legal limit/worn on edge Both Sides (5.2.3 (e))

Offside Brake pipe corroded, covered in grease or other material Front To Rear (1.1.11 (c))

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Brake pipe slightly corroded Front To Rear (3.6.B.2c)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Front Lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.D.2c)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)