2008 Audi Q7

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Emissions unable to be completed Due to coolant leak (8.2.2.2 (e))

Coolant leak ()

Offside Front Nail in tyre ()

Offside Rear Tyre worn close to legal limit/worn on edge Inner edge (5.2.3 (e))

Nearside Front Passenger's seat insecure needs bolting in (6.2.6 (a) (ii)) DANGEROUS

Nearside Rear Inner Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Inner Tyre worn close to legal limit/worn on edge 2.6mm (5.2.3 (e))

both front tyres close to legal limit

front pads low

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Suspension arm corroded but not seriously weakened both rear rusty (5.3.3 (b) (i))

Front Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Inner Rear position lamp(s) not working (1.1.A.3b)

Offside Inner Stop lamp not working (1.2.1b)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Rear position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Power steering pipe(s) or hose(s) slightly corroded (2.3.2)

slight oil leak

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Stop lamp has light sources not illuminating, but not more than 50% (1.2.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Stop lamp not working (1.2.1b)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)