2003 MG Zr

Front Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Rear Tyre slightly damaged/cracking or perishing Both (5.2.3 (d) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Suspension component pin or bush slightly worn (5.3.4 (a) (i))

Rear Tyre slightly damaged/cracking or perishing Both (5.2.3 (d) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits Exhaust wiring disconnected. (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust system thin throughout

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake pipe excessively corroded rear 1/2 of offside front to rear (3.6.B.2c)

Brake pipe excessively corroded rear 1/2 of offside front to rear (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases front flexible joint (7.1.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Exhaust has a major leak of exhaust gases middle and rear section (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Exhaust system not adequately supported (7.1.1)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front constant velocity joint is insecure (2.5.C.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

front brake application uneven (3.7.B.2)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Stop lamp not working (1.2.1b)