2013 Hyundai I20

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

hand brake lever has little reserve travel

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge BALD EDGES. (5.2.3 (e))

Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split (6.1.7 (g) (ii))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Brake performance not tested (1.2.1 (g))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure Bulge on the inner side wall (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre slightly damaged/cracking or perishing small splits on the inner side wall (5.2.3 (d) (ii))

Nearside Front Tyre inside sidewall slight damage

Offside Rear Child Seat fitted not allowing full inspection of adult belt ()

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.0mm (4.1.E.2b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre tread depth below requirements of 1.0mm (4.1.E.2b)