2004 Subaru Impreza

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Inner Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security wheel arch (6.2.2 (d) (i))

Nearside Rear Integral body structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Front Integral body structure is modified but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Rear Inner Fuel Pipe/s corroded ()

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting WHEEL ARCH (6.2.2 (d) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting ARCH (6.2.2 (d) (i))

Nearside Front tyre worn smooth on edges

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Registration plate inscription illegible (0.1 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front tyre worn smooth on edges

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

high handbrake travel

Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Central Front Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Central Front Exhaust has a major leak of exhaust gases joint split (7.1.2)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front coil spring broken (2.4.C.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar locating pin insecure (2.4.G.3a)

Rear Rear fog lamp not working (1.3.2b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tie bar/rod fractured (2.4.G.1)

Front Brake pad(s) wearing thin (3.5.1g)

Registration plate lamp not working (1.1.5c)