2005 Lexus IS200

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security nearside rear inner sill section (6.2.2 (d) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security offside rear inner sill section (6.2.2 (d) (i))

Suspension component mounting prescribed area is corroded but not considered excessive nearside rear inner sills (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive offside rear inner sills (5.3.6 (a) (i))

Anti-roll bar linkage ball joint excessively worn nearside front (5.3.4 (a) (i))

Anti-roll bar linkage ball joint excessively worn offside front (5.3.4 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Registration plate lamp does not illuminate simultaneously with the position lamps nearside (4.7.2 (a))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security front inner sill sections both sides (6.2.2 (d) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security nearside rear inner sill section (6.2.2 (d) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security offside rear inner lower sill section (6.2.2 (d) (i))

Suspension component mounting prescribed area is corroded but not considered excessive nearside rear inner sills (5.3.6 (a) (i))

Nearside Registration plate lamp not working (1.1.C.1d)

N/s/r tyre cut not deep enough to reach ply or cords.

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Tyre worn close to the legal limit (4.1.E.1)