2008 Toyota Aygo

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension arm corroded but not seriously weakened axle (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both outer sills, under sills, chassis rails, floors and inner flitches (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Exhaust system insecure front bracket missing (6.1.2 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner flitch / end of sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension arm corroded but not seriously weakened axle (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both outer sills, under sills, chassis rails, floors and inner flitches (5.3.6 (a) (i))

exhaust bracket broken centre

Exhaust emissions likely to be affected by an exhaust leak back box (8.2.2.1 (b))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

exhaust bracket broken centre

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both (5.1.2 (b) (i))

Rear both rear outer sills heavily under sealed

Suspension component mounting prescribed area is corroded but not considered excessive front and rear subframes (5.3.6 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both (5.1.2 (b) (i))

Rear both rear outer sills heavily under sealed

Suspension component mounting prescribed area is corroded but not considered excessive front and rear subframes (5.3.6 (a) (i))

Nearside sill repair heavily undersealed

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Position lamp not working (4.2.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Service brake lagging in operation (1.2.1 (d))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

n /s outer sill corroded

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement back bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement back bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pipe slightly corroded all coated in grease (3.6.B.2c)

brake pipes coated in grease

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too far to the left (1.8)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

offside rear wheel bearing slightly rough on rotation

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

FRONT BRAKE DISCS CORRODED