2009 Peugeot 107

Horn not working (7.7 (a))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced surface corrosion (6.1.1 (c) (i))

Nearside Front radiator support corroded

Nearside Rear Brake pipe corroded, covered in grease or other material brake pipe corroded (1.1.11 (c))

Offside Front Anti-lock braking system wiring damaged but not excessively abs wiring rubbing on wheel (1.6 (d))

Offside Rear Brake pipe corroded, covered in grease or other material brake pipe greased (1.1.11 (c))

Rear Suspension arm corroded but not seriously weakened surface corrosion (5.3.3 (b) (i))

Rear rear crash bar surface corrosion

Brake pipe corroded, covered in grease or other material all pipe ends greased (1.1.11 (c))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Horn not working (7.7 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Brake pipe corroded, covered in grease or other material all pipe ends greased (1.1.11 (c))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material light corrosion (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge worn inside edge (5.2.3 (e))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill surface corrosion (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material both rear (1.1.11 (c))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced surface corrosion (6.1.1 (c) (i))

nsf radiator mounting bracket corroded

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced hole in inner sill (6.1.1 (c) (i))

Offside Headlamp aim too low (4.1.2 (a))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material light corrosion (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge worn inside edge (5.2.3 (e))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill surface corrosion (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material both rear (1.1.11 (c))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced surface corrosion (6.1.1 (c) (i))

nsf radiator mounting bracket corroded

Central Obligatory mirror slightly damaged (3.3 (b) (i))

Front radiator support badly corroded

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement cracking. (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush. (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement cracking (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush. (5.3.4 (a) (i))

rear tyres 10 years old.

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement cracking. (5.3.4 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated pin hole. (6.1.7 (g) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush. (5.3.4 (a) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement cracking (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush. (5.3.4 (a) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

rear tyres 10 years old.

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

front panel crossmember corroded.

interior mirror poor condition.

n/s headlamp has condensation, beam pattern dull.

rear brakes binding slightly

near side front chasssis and radiator support panel damaged and corroded

Horn not working (1.6.2a)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front radiator support panel damaged and corroded

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)