2004 Fiat Doblo

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Suspension component mounting repair covered in underseal sills (5.3.6 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Suspension component pin or bush slightly worn shock absorber (5.3.4 (a) (i))

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too low and too far to the left. (1.8)

Offside Headlamp insecure (1.7.3)

Offside Rear Leaf spring fractured (2.4.B.1a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Headlamp aim too low (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Registration plate lamp not working (1.1.5c)

Nearside Headlamp aim too low (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too low (1.8)