2008 Toyota Aygo

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

slight corrosion underbody

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Nearside Front Suspension arm pin or bush likely to become detached wishbone rear bush (5.3.4 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Seat belt buckle not functioning as intended jammed (7.1.2 (d))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Steering locking device missing ball joint split pin missing (2.1.3 (d))

Nearside Headlamp aim too far to the right (4.1.2 (a))

Offside Front Lower Steering locking device missing ball joint split pin missing (2.1.3 (d))

Offside Headlamp aim too far to the right (4.1.2 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre tread depth below requirements of 1.0mm (4.1.E.2b)

Offside Rear Tyre tread depth below requirements of 1.0mm (4.1.E.2b)