2008 Mazda 6

Nearside Rear Anti-roll bar linkage damaged but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Parking brake lever has little reserve travel

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Exhaust system starting to corrode

Rear note rear suspension subframe and components corroded

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear note rear suspension subframe and components corroded

Offside Rear brake disc worn, pitted or scored, but not seriously weakened corroded (3.5.1i)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

general corrosion at prescribed area+suspension componenets

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

general corrosion at prescribed area+suspension componenets

Offside Front position lamp(s) not working (1.1.A.3b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

nearside front tyre wearing low edges.