2010 Yamaha Wr 125 X

Rear Shock absorber has a slightly worn bush LOWER BUSH HAS SLIGHT PLAY (5.3.2 (c))

vin number stARTING TO GET HARD TO SEE

Rear Position lamp not working (4.2.1 (a))

Rear Shock absorber has a slightly worn bush LOWER BUSH HAS SLIGHT PLAY (5.3.2 (c))

vin number stARTING TO GET HARD TO SEE

Drive chain excessively loose (6.1.7 (c) (i))

Drive chain sprocket worn to excess (6.1.7 (c) (i))

Front Position lamp missing (4.2.1 (a))

Front Shock absorber has negligible damping effect (5.3.2 (b))

Headlamp aim too low (4.1.2 (a))

Rear Footrest missing both sides (6.2.12 (a))

Stop lamp not working FRONT OR REAR (4.3.1 (a) (ii))

Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

EML light on

Front Wheel spoke slightly loose (5.2.2 (d))

Rear Tyre worn close to the legal limit (5.2.3 (e))

clocks insecure

clutch and brake lever shortened

speedo drive insecure fouling tyre

Rear Tyre worn close to the legal limit (4.1.3(ii))

All position lamps do not illuminate immediately when switched on no plate light inop. (1.1.3a)

Front Brake hose stretched by suspension movement cable tied to strut (3.2.B3b)

Front Tyre is incorrectly seated on the wheel rim (4.1.2b)

Headlamp aim too low (1.6)

Rear Wheel spoke excessively loose (4.2.1b)

Rear Wheel spoke missing (4.2.1b)

chain gaurd missing

Front Brake pad(s) (sintered type) less than 1.0mm thick NEAR TO METAL AND CONTAMINATED (3.2A1f(ii))

Front Drive chain sprocket worn to excess AND REAR (6.2.1e)

Rear Drive chain excessively loose BOTH CHAIN SPROCKETS ARE WORN OUT (6.2.1d)

Front Front shock absorber seal failed and leaking oil OIL ALL OVER BRAKES FROM FORKS (2.3.3) DANGEROUS

Front Tyre tread depth is below minimum requirements of 1.0mm BELOW LIMIT (4.1.3(ii)) DANGEROUS

FRONT BRAKE STICKING

Nearside Front Front shock absorber has light misting of stanchion (2.3.3)

Drive chain excessively loose (6.2.1d)

Nearside Front Front shock absorber seal failed and leaking oil (2.3.3)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)