2003 Toyota Celica

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced door shut marked in yellow chalk (6.1.1 (c) (i))

Rear Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Arches both marked in yellow chalk (6.1.1 (c) (i))

Front Suspension arm corroded but not seriously weakened Both (5.3.3 (b) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension arm corroded but not seriously weakened Both (5.3.3 (b) (i))

Front Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front bumper crash bar corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar linkage corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear bumper crash bar corroded

both front suspension arms corroded

integral body structure has slight surface corrosion all round but not considered excessive

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre has ply or cords damaged (5.2.3 (d) (ii)) DANGEROUS

Oil leaking continuously from engine posing a serious risk to road safety (8.4.1 (a) (ii)) DANGEROUS

Front Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front bumper crash bar corroded

Rear Anti-roll bar linkage corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear bumper crash bar corroded

both front suspension arms corroded

integral body structure has slight surface corrosion all round but not considered excessive

Rear Tyre worn close to legal limit/worn on edge Both (5.2.3 (e))

Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Rear Brake pipe excessively corroded Both (1.1.11 (c))

Rear Brake pad(s) wearing thin Both (1.1.13 (a) (ii))

Rear Tyre worn close to legal limit/worn on edge Both (5.2.3 (e))

corrosion to chassis

corrosion to front and rear suspension

rear brake discs corroded

white smoke from exhaust

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Windscreen washer not working (3.5 (a))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

corrosion to front and rear chassis

corrosion to rear suspension components

n/s/f cv boot split

n/s/r fog light insicure

rear number plate deteriorated

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Parking brake lever defective but can be satisfactorily operated travel high (1.1.6 (d))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Nearside Headlamp light source and lamp not compatible (4.1.4 (c))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Headlamp light source and lamp not compatible (4.1.4 (c))

Offside Rear Direction indicator incorrect colour flashing red (4.4.3 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Parking brake lever defective but can be satisfactorily operated travel high (1.1.6 (d))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Centre Front Parking brake lever has no reserve travel (3.1.6b)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Nearside Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear brake pad retaining pins welded into pad carriers at N/S/R and O/S/R

Rear pads cannot be removed without causing damage to brake componants

Offside Front Anti-roll bar ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front front brake application uneven (3.7.B.2)

Nearside Headlamp aim too high (1.8)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too high (1.8)

Offside Front Anti-roll bar ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Brake pad(s) wearing thin (3.5.1g)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Windscreen wiper blade insecure (8.2.2)

Offside Windscreen wiper blade insecure (8.2.2)

Front Brake pad(s) wearing thin (3.5.1g)

Parking brake lever has little reserve travel (3.1.6b)

Rear registration plate delaminated but not likely to be misread (6.3.1d)

front brake discs corroded

rear brake back plates corroded

rear brake discs scored

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front registration plate deteriorated (6.3.1d)

Offside Rear Registration plate lamp not working (1.1.5c)

N/S/R Tyre slight cracking on tread side wall

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

N/S/R Tyre slight cracking on tread side wall

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)