2004 MG ZS

HANDBRAKE LEVER SLIGHTLY INSECURE

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

OFFSIDE WASHER JET WEAK

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

REAR EXHAUST BAFFELS NOISEY

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Front Brake disc significantly and obviously worn INNER FACE (1.1.14 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength INNER WHEEL ARCH NEAR SUBFRAME MOUNT (5.3.6 (a) (i))

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

HANDBRAKE LEVER SLIGHTLY INSECURE

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

OFFSIDE WASHER JET WEAK

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

REAR EXHAUST BAFFELS NOISEY

Nearside Obligatory mirror insecure (3.3 (b) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under arch (5.3.6 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake pipe corroded, covered in grease or other material both front to rears at rear (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor near subframe (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor near subframe (5.3.6 (a) (i))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Brake pipe corroded, covered in grease or other material both front to rears at rear (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil leak ()

Supplementary Restraint System warning lamp does not illuminate (5.4.2)

Nearside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil leak ()

Supplementary Restraint System warning lamp does not illuminate (5.4.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Rear Tyre worn close to the legal limit (4.1.E.1)

Horn not working (1.6.2a)

Nearside Front front brake binding (3.7.B.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

front pads getting low

o/s/r trailing arm bush starting to lift on rubber bonding

rear exhaust centre and middle rusty