2003 Ford Transit Connect

Front Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Front Headlamp lens seriously defective both (4.1.1 (b) (ii))

Nearside Front Outer Tyre has a cut in excess of the requirements deep enough to reach the ply or cords sidewall (5.2.3 (d) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Offside Rear Leaf spring main leaf fractured (5.3.1 (b) (ii)) DANGEROUS

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Central Exhaust mounting defective (6.1.2 (a))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear lens defective

front lower crossmember support (rad) corroded

handbrake has little reserve travel

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Service brake efficiency below requirements (1.2.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Service brake excessively fluctuating (1.2.1 (e))

Windscreen wiper not working (3.4 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake pipe corroded, covered in grease or other material general corrosion to all brake pipes (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear boot floor corroded

Emissions not tested (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake pipe corroded, covered in grease or other material general corrosion to all brake pipes (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Rear boot floor corroded

several welding repairs carried out to underside of vehicle

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Tyre worn close to the legal limit worn uneven (4.1.E.1)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (inner sill) (2.4.A.3)

Offside Rear Tyre worn close to the legal limit worn uneven (4.1.E.1)

Central Exhaust system not adequately supported (7.1.1)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside rear brake binding (3.7.B.1)

Nearside rear brake excessively fluctuating (3.7.B.3)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear rear brake binding (3.7.B.1)

Offside rear brake excessively fluctuating (3.7.B.3)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

rear parking (secondary) brakes imbalanced 51% (3.7.B.6b)

LPG fuel tank has some corrosion

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

LPG tank has slight corrosion

front brake pads wearing down

front to rear brake pipes hidden behind under-trays and fuel tank so not inspected

offside rear brake sticky

rear brakes have uneven application developing

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Body has a sharp edge caused by damage (6.1.C.1)

Offside Front position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Body has a sharp edge caused by damage (6.1.C.1)

front brake pads wearing down

LPG tank has slight corrosion

front to rear brake pipes hidden behind under-trays and fuel tank so not inspected

offside rear brake sticky

rear brakes have uneven application developing

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

clutch staring to slipp

Centre Stop lamp not working (1.2.1b)