2005 Fiat Doblo

Central Rear Upper Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material Main at tank (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Inner Tyre worn close to legal limit/worn on edge Edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Gearbox mounting defective lower swing mounting spliiting. ()

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge wearing on inner edge.175/70r14 (5.2.3 (e))

Oil leak, but not excessive intercooler join. (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material greased (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside front brake application uneven (3.7.B.2)

Offside front brake excessively fluctuating (3.7.B.3)

Nearside Rear Statutory seat belt missing (5.1.1)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside front brake fluctuating, but not excessively (3.7.B.3)

Both front tyres are worn on inner edge

Both rear bump stops deteriorated

Power steering component(s) has slight seepage from a seal (2.3.3b)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Both front tyres are worn on inner edge

Both rear bump stops deteriorated

Power steering component(s) has slight seepage from a seal (2.3.3b)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Headlamp aim too far to the left (1.8)

Offside Front Headlamp aim too low (1.8)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

n/s and o/s rear tyres are cracking on sidewalls

o/s front tyre wearing on inside edge

n/s and o/s rear tyres are cracking on sidewalls

o/s front tyre wearing on inside edge

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)