2008 Toyota Aygo

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill/axle mounting area (5.3.6 (a) (i))

Offside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced full sill (6.1.1 (c) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush, both sides (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge both tyres, wear bars (5.2.3 (e))

Headlamp has a product on the lens but not seriously reducing light output both sides,misty (4.1.4 (b))

Nearside Rear Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

Sub-frame corroded but not seriously weakened front and rear (5.3.3 (b) (i))

Tyre slightly damaged/cracking or perishing all tyres cracking (5.2.3 (d) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced general underside corrosion (6.1.1 (c) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced general underside corrosion withstood CAT (6.1.1 (c) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced general underside corrosion, withstood CAT (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases middle section (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear brake binding

Offside Rear Brake pipe corroded, covered in grease or other material main (1.1.11 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

both front tyres close to legal limit

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Brake pipe corroded, covered in grease or other material main to rear (1.1.11 (c))

both front tyres close to legal limit

Offside Front Lower Suspension arm synthetic bush deteriorated but not resulting in excessive movement rear (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Brake pipe excessively corroded (3.6.B.2c)

front brake disc's worn & in poor condition

front exhaust bracket corroded

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside and offside front brake disc's slightly worn

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside rear tyre slightly deteriorated

Nearside rear wheel bearing slightly rough when rotated