2003 MG Zr

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases rear last joint to back box (6.1.2 (a))

Fuel Pipe/s corroded all front to rear ()

Nearside Inner Suspension component mounting prescribed area is corroded but not considered excessive and outer sills front to rear (5.3.6 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Inner Suspension component mounting prescribed area is corroded but not considered excessive and outer sills front to rear (5.3.6 (a) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

front to rear vehicle`s under body is corroded

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust has a minor leak of exhaust gases rear joint (6.1.2 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner/outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner/outer sill (5.3.6 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside wiper slightly worn

Rear Inner both sills corroded

exhaust down pipe mounting corroded

fuel and brake pipes local to fuel tank corroded

Nearside Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside wiper slightly worn

Rear Inner both sills corroded

exhaust down pipe mounting corroded

fuel and brake pipes local to fuel tank corroded

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases at rear joint (7.1.2)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside rear brake excessively fluctuating (3.7.B.3)

Parking brake: efficiency below requirements (3.7.B.7)

Near side front tyre has a small cut to side wall.

Near side tyre starting to crack on side wall.

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Outer Rear brake drum excessively pitted (3.5.1h)