2003 Volkswagen Caddy

Nearside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced chassis leg (6.1.1 (c) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Brake pipe corroded, covered in grease or other material front to rears mid sections (1.1.11 (c))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis leg (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Brake pipe corroded, covered in grease or other material front to rears mid sections (1.1.11 (c))

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Rear Lower Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength mid outer sill (5.3.6 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i))

Nearside Parking brake inoperative on one side low (1.4.1 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Brake pipe corroded, covered in grease or other material both front to rear at rear section (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement bottom arm rear bush (2.4.G.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Nail in tyre ()

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake lever has little reserve travel (3.1.6b)

Under-trays fitted obscuring some underside components

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Front Brake pipe slightly corroded (3.6.B.2c)