2004 Daihatsu Terios

Emissions unable to be completed (8.2.1.2 (d))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced center (6.1.1 (c) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced center (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust fumes causing a danger to health of persons on board tail pipe missing (6.1.2 (b) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Integral body structure is repaired but structural rigidity is not significantly reduced outer sill (6.1.1 (d) (i))

Nearside Rear Integral body structure is repaired but structural rigidity is not significantly reduced inner wheel arch (6.1.1 (d) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Integral body structure is repaired but structural rigidity is not significantly reduced outer sill (6.1.1 (d) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wheel arch (6.1.1 (c) (i))

Nearside Rear Seat belt retracting mechanism defective (7.1.2 (e))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Registration plate lamp insecure (4.7.1 (c) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mount (5.3.6 (a) (i))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced center (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wing (6.1.1 (c) (i))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced center (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Nail in tyre ()

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

n/s/r and o/s/r wheel arches corroded

Nearside Rear Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

n/s/r and o/s/r wheel arches corroded

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Rear Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside rear parking (secondary) brakes imbalanced (3.7.B.6b)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Brake pipe excessively corroded nearside front to rear brake (3.6.B.2c)

Brake pipe excessively corroded offside front to rear brake (3.6.B.2c)

Nearside Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

front tyres wearing on inner edges

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front position lamp(s) not working (1.1.A.3b)

continental stickers on headlights

front discs pitting

Nearside front brake binding (3.7.B.1)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

continental stickers on headlights

front discs pitting

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)