2006 Daihatsu Charade

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Rear Coil spring corroded Both (5.3.1 (b) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Exhaust silencer insecure (8.1.1 (b) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting spring mounting (6.2.2 (d) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sills (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting rear spring mounting (6.2.2 (d) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe slightly damaged (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Exhaust system not adequately supported (7.1.1)

Nearside Stop lamp not working (1.2.1b)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust has a minor leak of exhaust gases 0 2 SENSOR (7.1.2)

Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt INNER BOOT (2.5.C.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)