2007 Subaru Impreza

Exhaust noisy (8.1.1 (a))

Nearside Rear Brake pipe clips or supports missing, pipe adequately supported (1.1.11 (d) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Outer Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Exhaust noisy (8.1.1 (a))

Nearside Rear Brake pipe clips or supports missing, pipe adequately supported (1.1.11 (d) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill (5.3.6 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge on 3mm and wearing on outer edge (5.2.3 (e))

Nearside Rear brake hose insecure

Offside Front Tyre slightly damaged outer sidewall (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

both rear inner sills corroded

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge on 3mm and wearing on outer edge (5.2.3 (e))

Nearside Rear brake hose insecure

Offside Front Tyre slightly damaged outer sidewall (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

both rear inner sills corroded

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Registration plate insecure but not likely to fall off (0.1 (a))

Nearside Rear Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

bonnet catch faulty

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust engine idle speed too high (7.3.D.1)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has a minor leak of exhaust gases front pipe (7.1.2)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

eml on

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Headlamp aim not tested (1.8.A.1c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)