2006 Jaguar X-type

Emissions unable to be completed excessive smoke emitted (8.2.2.2 (e))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Horn not working (7.7 (a))

Nearside Headlamp has a product on the lens so that the light output is severely reduced no beam pattern (4.1.4 (b))

Offside Tyre has a cut in excess of the requirements deep enough to reach the ply or cords front and rear tyre (5.2.3 (d) (i))

Rear Anti-roll bar pin or bush excessively worn both d bushes (5.3.4 (a) (i))

Seat belt anchorage prescribed area strength or continuity significantly reduced both outer sills (7.1.1 (a) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake disc worn, pitted or scored, but not seriously weakened all (1.1.14 (a) (ii))

Brake hose slightly deteriorated all (1.1.12 (b) (ii))

Coil spring corroded all (5.3.1 (b) (i))

Front Tyre worn close to legal limit/worn on edge both 2225/45r17 (5.2.3 (e))

Items removed from driver's view prior to test ()

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated is secure but has grease around it (6.1.7 (g) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output on pass limit (4.1.4 (b))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Both front tyres worn on inner edge

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Lower Suspension arm pin or bush excessively worn tie bar (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Engine covers fitted

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Under shield fitted

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

nsr trailing arm front bush deteriorated

osr trailing arm front bush deteriorated

o/s/front tyre wearing low on inner tread edge

o/s/rear tyre worn low and uneven on inner tread edge

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

o/s/front tyre wearing low on inner tread edge

o/s/rear tyre worn low and uneven on inner tread edge

small cuts in osf tyre wall and wearing slightly on inner edge