2012 Ford Ranger

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Rear Fuel system component leaking (6.1.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Brake hose has slight corrosion to ferrule most need greasing (1.1.12 (f) (i))

Brake pipe corroded, covered in grease or other material most (1.1.11 (c))

Integral body structure is corroded but structural rigidity is not significantly reduced needs cleaning off and a treatment applied including the suspension areas (6.1.1 (c) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Brake pipe corroded, covered in grease or other material All pipe ends to each wheel and central (1.1.11 (c))

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Nearside Front Outer cv boot damaged but not allowing ingress of dirt

Nearside Front worn on inner edge

exhaust centre box outer skin corroded but not blowing

Nearside Rear Position lamp not working (4.2.1 (a))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Central exhaust silencer box outer skin corroded

Nearside Front Outer cv boot weeping grease from inner end

Nearside Front tyre wearing on inner edge

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Tyre slightly damaged/valve stem damaged stem cracked (5.2.3 (d) (i))

Offside Front Valve stem slightly damaged (4.1.D.1e)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)