2004 Kia Carens

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake hose has slight corrosion to ferrules All (3.6.B.4e)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sil/ wheel house (2.4.A.3)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt both sides (2.5.C.1a)

Rear Exhaust has a minor leak of exhaust gases Joint (7.1.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Brake hose has slight corrosion to ferrules All (3.6.B.4e)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear exhaust bracket broken but system still adequately supported

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front brake discs worn

offside front brake slight bind

Nearside Front Brake pipe excessively corroded on shocker (3.6.B.2c)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords inner sidewall (4.1.D.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Front Brake pipe excessively corroded on shocker (3.6.B.2c)

Offside Rear Body has a sharp edge caused by corrosion wheel arch (6.1.C.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front brake discs worn

offside front brake slight bind

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Outer Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Outer Rear Brake pipe excessively corroded (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate delaminated (6.3.1d)

Rear registration plate deteriorated (6.3.1d)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside rear brake juddering severely (3.7.A.5b)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)